Raymarine SeaTalk2 Guia de Configuração descarregar pdf (Página 51)

Chapter 3: Commissioning & Setup 43

9. If the AutoLearn was successful, hold down

standby

for 2 seconds to store the

new settings.

Commissioning complete

If you have successfully completed the dockside preparation and seatrial calibration,

the SPX system is now commissioned and ready for use.

After having used your SPX-5 Sport system, you may decide to change the value of

some parameters to improve pilot performance with your boat. If you feel this is

necessary, use the appropriate procedures under

Manual setup

, below.

3.2 Manual setup

Checking SPX-5 Sport system operation

Before manually adjusting any settings, familiarize yourself with basic SPX-5 Sport

system operation, as follows:

1. Steer onto a compass heading and hold the course steady at a normal cruising

speed. If necessary, steer the boat manually for a short time to check how the boat

steers.

2. Press

auto

to lock onto the current heading. The SPX-5 Sport system should hold

a constant heading in calm sea conditions.

3. Use

-1, +1, -10

and

+10

to see how the SmartPilot alters the course to port and

starboard.

4. Press

standby

to return to manual steering.

Adjustable parameters

If you feel you need to fine tune the SPX-5 Sport system performance, you can do so

by using one or more of the procedures below to adjust:

• Rudder gain.

• Counter rudder

• AutoTrim.

Over time you may wish to repeat these adjustments using a range of sea conditions

and headings to achieve optimum all-round performance for your particular vessel

and preferences.

Adjust these settings when motoring your boat at cruising speed. For further

information on adjustable parameters, refer to

Chapter 4: SmartPilot X-5 Sport

Settings

Setting response level

Before proceeding with any manual adjustment, set the response level to

as follows:

1. Enter Dealer calibration as described on

page 35

2. Use

disp

as necessary to access the

RESPONSE

screen.

3. Use the

-1

key or the

and

down

arrow keys to set a response of

4. Hold down

standby

for 2 seconds to save the setting and leave Dealer calibration.

87076_1.book Page 43 Monday, March 10, 2008 2:57 PM

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 73 74

Comentários a estes Manuais

Sem comentários

Raymarine SeaTalk2 Guia de Configuração Página 51

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de navegação Raymarine SeaTalk2