Raymarine VolvoPenta IPS Autopilot System DPU Manual de Instalação descarregar pdf (Página 28)

18 SmartPilot Series Commissioning Guide

4. Secure the cable clamp using the self-tapping screws supplied

(No 8 x

in, pan-head), making sure:

• the tie-wrap securing loops are on the right (below the

POWER and

MOTOR terminals on the computer)

• the clamp securely holds all cables

• the legs on cable clamp do not pinch any of the cables

Note:

If the power and/or motor cables are larger than 5 mm (

in) diameter, secure them

on top of the cable clamp with the tie-wrap supplied. Make sure the tie-wrap sits above the

cables (as shown below), so it pulls the cables against the clamp when tightened.

D6380-1

D6381-1

1 2

81273_1.book Page 18 Monday, December 5, 2005 10:32 AM

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 79 80

SmartPilot 1
Commissioning 1
Important Information 3
Safety notices 4
EMC Guidelines 5
Handbook information 6
Contents 7
Chapter 1: System Connections 11
1.2 The SmartPilot computer 12
S1 Systems S2 and S3 Systems 13
S1 Systems 14
S2 and S3 Systems 14
. Power the CR pump 15
16
1.5 Fuse Protection 18
Securing the Cables 19
SeaTalk B 20
SeaTalk A 20
SeaTalk bus 20
Do not connect Red wire 21
(Cut back and insulate) 21
SmartPilot computer terminals 22
NMEA connectivity overview 23
GyroPlus yaw sensor 24
Handheld remotes 24
External alarm 25
Wind vane (sail boats) 25
Off switch (S2 and S3 only) 25
in) diameter, secure them 28
2.1 Dockside Checks 29
Step 1 - Switch on 30
NMEA navigator connections 31
Wind instrument connections 31
Chapter 3, Adjusting Settings 32
Enter Dealer Calibration mode 33
Set the vessel type 33
Set the rudder limits 36
Save the new settings 36
2.2 Seatrial Calibration 37
Calibrating the compass 38
(see below) 39
Align the autopilot heading 40
Save changes 40
AutoLearn 41
Before proceeding, ensure 42
Boat completes AutoLearn 43
Save new settings 43
Manual set-up: Non-G Systems 44
Adjusting the rudder gain 45
Adjusting the counter rudder 46
Further adjustments (Non-G) 47
3.1 Calibration basics 49
key for 50
3.2 Display Calibration 51
Display Calibration screens 52
Data pages 53
3.3 User Calibration 54
3.4 Seatrial Calibration 55
3.5 Dealer Calibration 55
Accessing 56
Dealer Calibration 56
SeaTrial Calibration lock 57
Vessel type 57
Drive type 58
Align rudder 58
Rudder limit 59
Rudder gain 59
Counter rudder 59
Rudder damping 60
AutoTrim 60
Response level 61
Turn rate limit 61
Off course warning angle 62
Joystick mode (PWR STEER) 62
AutoRelease (I/O drives only) 63
AutoTack angle 63
Gybe inhibit 63
Wind selection 64
WindTrim (wind response) 64
Cruise speed 64
AutoAdapt 65
Latitude 65
System reset 66
Dealer Calibration defaults 67
Dealer Calibration options 68
4.1 Fault finding 69
SmartPilot alarm messages 70
4.2 Maintenance 72
Product support 73
SmartPilot Specifications 75
Glossary 77

Comentários a estes Manuais

Sem comentários

Raymarine VolvoPenta IPS Autopilot System DPU Manual de Instalação Página 28

Comentários a estes Manuais