Raymarine S100 Guia de Instalação descarregar pdf (Página 10)

8 S1000 Autopilot Installation Guide

Note: The hydraulic fittings supplied with the autopilot pump have sealant pre-

applied to the tapered threads. You only need to apply sealant to any extra joints

you may obtain. The recommended sealant for doing this, is Loctite 542.

Do not use sealing tape on any part of a hydraulic system, as this can

disintegrate and the resulting particles can cause blockages in the

hydraulic system.

CAUTION:

D7545-1

Tapered thread

Thread for hose

connection

Sealing hydraulic joints

Do not apply sealant to

hose connection thread.

1.5 turns

D7546-1

From hand tight, use a wrench to tighten the joint a

further 1.5 turns. This should make it leakproof.

To change the orientation of the joint to align it with the

hose, further tighten the joint, to a maximum of one

further turn, until the joint is facing the required

direction.

Hand tighten

CAUTION:

Do not exceed 13 ft/lbs

(17.6 Nm) torque.

CAUTION:

Do not exceed 13 ft/lbs (17.6 Nm) torque.

DO NOT EXCEED 2.5 TURNS in total, from

hand tight.

Installing tapered thread fittings

87040_5.book Page 8 Monday, April 30, 2007 5:58 PM

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 35 36

Jack 29 May 2025 | 01:45:11

Manual for s100 autopilot

Raymarine S100 Guia de Instalação Página 10