Raymarine 465 Especificações descarregar pdf (Página 21)

Chapter 2: Installation 11

1. Select a suitable area which allows access to the underside of the

mounting surface for fixing and, using the template supplied in this

document, carefully drill the two 6mm (0.25in) fixing holes marked.

2. If the cable is to pass through the mounting surface drill the 6mm

(0.25in) or 19mm (0.75in) center hole depending on whether the plug

is to pass through the surface or not.

If the cable is to exit from the side of the GPS Antenna above the

mounting surface, remove the two plastic tabs (1) obstructing the

cable channel.

Note: Failure to remove the plastic tabs from within the cable channel

could result in cable damage.

3. Screw the supplied brass studs (2) into the underside of the GPS

Antenna.

4. Stick the supplied gasket (3) to the mounting surface ensuring that the

holes match and pass the cable through the center hole or the cable

exit channel.

5. Carefully position the GPS Antenna, passing the studs through the

holes in the mounting surface and secure to the mounting surface

using the thumb nuts provided (4).

81236_1.book Page 11 Monday, January 5, 2004 3:41 PM

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 131 132

Sem comentários

Raymarine 465 Especificações Página 21