Raymarine SmartPilot SPX-30 Manual de Instalação descarregar pdf (Página 18)

Drive setup

1. Press

ENTER

to begin drive setup

2. Press

ENTER

to select drive type from the

following:

• Type 1 or 2 linear

• Type 2 or 3 hydraulic linear

• I/O stern

•IPS

• Jet drive (pump or fly-by-wire)

• Wheel drive

• Tiller

• CR solenoid

•Sport drive

• Type 1 or 2 rotary

• Type 1, 2 or 3 hydraulic pump

• Constant running pump

•Verado

If you drive type is not listed, contact your Raymarine dealer for advice.

Rudder check

WARNING: If no rudder reference has been fitted you MUST ensure that

adequate provision is made to prevent the steering mechanism from

impacting the end stops.

Note: Systems without a rudder reference will skip this section and go straight to seatrial cali-

bration.

This procedure establishes port and starboard rudder limits. Fine-tuning adjustments

to the rudder position may be made during seatrial calibration. You can exit this

procedure at any time by pressing

CANCEL

Press ENTER to select.

Drive Type

Type 1 Linear

D10888-1

Please select your boat's drive

type.

81287_1.book Page 10 Tuesday, March 18, 2008 11:50 AM

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

Sem comentários

Raymarine SmartPilot SPX-30 Manual de Instalação Página 18