Raymarine SmartPilot SPX-30 Manual de Instalação descarregar pdf (Página 25)

Chapter 3: Check and adjust settings 17

Chapter 3: Check and adjust settings

3.1 Introduction

Many installations will require fine tuning. If you are a professional installer, ensure

you check the autopilot settings before handing the system over to the customer.

3.2 Vessel settings

You can adjust the following vessel settings to more accurately reflect your boat’s

particular setup and what you will be using your autopilot system for.

Setting Vessel Type

CAUTION: Vessel Type determines other parameters

If you change the Vessel Type, you must then ensure all other parameters

are set as you require before using the boat, as some other parameters

change when the Vessel Type changes.

The vessel type options will normally give optimum performance for typical vessels of

each type. However, you may find you can improve the performance of your vessel by

selecting an option for a different vessel type.

1. At the

Advanced Options

menu, use < and > to select

Vessel Type

, then press

ENTER

to display the

Vessel Type

menu.

2. Use < and > to select the required Vessel Type, then press

ENTER

to save and

exit the menu.

Refer to Select Vessel Type on page 7 for more details.

Drive type

Refer to Drive setup on page 10 for more details.

Auto release (mechanical stern drive only)

.Auto release allows you to override the pilot by

taking hold of the wheel or tiller. When you release

the wheel or tiller, the pilot will return to the last

locked heading.

1. Use < or > to switch auto release on or off.

2. Press

ENTER

to accept the new value.

Press ENTER to select.

Auto Release

D10879-1

Enable/Disable auto release.

81287_1.book Page 17 Tuesday, March 18, 2008 11:50 AM

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 47 48

Comentários a estes Manuais

Sem comentários

Raymarine SmartPilot SPX-30 Manual de Instalação Página 25

Comentários a estes Manuais