Raymarine SmartPilot SPX-SAL Guia de Configuração descarregar pdf (Página 37)

Chapter 2: Installing the system 29

2.10Final checks

When you have completed all necessary installation procedures, but before you

apply power to the system, ensure all equipment and connections are properly

secured.

Secure all cables

To prevent strain on the connector blocks, secure the cables to the Course Computer

with cable ties as shown below.

2.11Commission the system before use

The autopilot must be commissioned prior to use. For new systems this involves

calibrating the system, which is a safety-critical action.

Refer to Section Chapter 3:, Commissioning & Setup for instructions.

D10396-1

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 75 76

SmartPilot X-5R 1
Contents 3
Safety notices 7
EMC Conformance 7
Pressure washing 7
Warranty 8
Product disposal 8
1.1 Installation overview 9
Product documents 10
Example SeaTalk system 11
1.3 Equipment & Tools 12
2.1 Installation requirements 15
Power cable requirement 16
Mounting 17
D10375-1 18
2.4 Mounting the Drive 19
/4 inch diameter. If the 20
3/4 inch Steering Shaft 21
1 inch Steering Shaft 21
D10378-2 22
D10379-2 23
D10380-1 23
Step 5- Fit Drive unit 24
3/4 inch shaft fitting 25
1 inch shaft fitting 26
Watertight 27
Computer 28
2.6 Fluxgate Compass 29
Mounting procedure 30
Compass connection 30
Pilot Controller 31
D10644-1 32
D10645-1 32
2.8 Connect to ground 33
Rudder transducer 34
Connections 35
NMEA 0183 equipment 36
2.10Final checks 37
Requirement 39
Power assisted steering 39
Rudder reference information 39
3.1 Commissioning 40
D10646-1 42
Setup map 43
Align the rudder indicator 44
Set the rudder limits 44
Seatrial calibration 45
(see below) 46
Aligning the compass heading 47
AutoLearn 48
AutoLearn procedure 49
Before proceeding, ensure 50
Boat completes AutoLearn 51
Save new settings 51
3.2 Manual setup 52
Rudder gain 53
Counter rudder 54
AutoTrim 54
Rudder damping 55
4.1 Introduction 57
Adjusting calibration values 58
Accessing Display 59
Calibration 59
The RUDD BAR parameters are 59
Setting up data pages 60
Accessing User 61
4.4 Dealer calibration 62
Vessel type 63
Drive type 64
Align rudder 64
Rudder limit 64
Response level 65
Turn rate limit 66
Off course angle 66
PowerSteer 66
Cruise speed 67
Latitude 67
System reset 67
4.5 System defaults 68
NMEA0183 to Course Computer 69
Course Computer 71
Pilot Controller (ST6002) 73

Comentários a estes Manuais

Sem comentários

Raymarine SmartPilot SPX-SAL Guia de Configuração Página 37

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de navegação Raymarine SmartPilot SPX-SAL