Raymarine E Series Guia de Instalação descarregar pdf (Página 42)

3-8 E-Series Networked Display Reference Manual

Moving a waypoint

You can move any waypoint to a new position. If, however, you are navigating to a

waypoint and you wish it to be moved, you will need to stop navigation (Press STOP

GOTO). There are two methods of moving a waypoint:

...by entering new coordinates

If you know the new co-ordinates, bearing or range for the particular waypoint, you

can enter this information by editing the waypoint as described above.

...by dragging the waypoint to a new position

1. Use the cursor to select the waypoint that you want to move.

2. Press MOVE WAYPOINT.

3. Use the trackpad to drag the waypoint to the new location.

4. Press PLACE WAYPOINT or OK to save.

Note:

Press

CANCEL

to abandon the move.

CAUTION:

It is possible to move waypoints that are used in routes. In such instances, the

stored route will include the Waypoint in its new position. Ensure that this

does not present a navigation hazard.

Erasing a waypoint

You can erase any waypoint on the system (including groups of waypoints) except:

• The waypoint that you are currently navigating to.

OR:

• Any waypoint used in a route.

Note:

Routes may be hidden but its waypoints can still be displayed. If you attempt

to erase such a waypoint, a warning message will be displayed

...using the cursor

1. Move the cursor over the waypoint that you want to erase.

2. Press ERASE WAYPOINT.

3. You will then be asked to confirm this. Press YES to confirm, or NO to cancel.

...using the waypoint list

1. Select the waypoint in the waypoint list.

2. Press ERASE WAYPOINT.

3. You will then be asked to confirm this. Press YES to confirm, or NO to cancel.

Note:

For details of erasing groups of waypoints, see page 3-12.

81244_1.book Page 8 Wednesday, December 1, 2004 11:41 AM

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 197 198

Sem comentários

Raymarine E Series Guia de Instalação Página 42